I would first verify your Harmony Elite hub is updated to the XMPP developer firmware. I just run an immediate script command (http to the IP address). The trigger is essentially the same as yours, but I am not using any Denon plugins. I am doing something very similar, and it is working fine for me. I have also changed it to IF "An Activity Has Started" but that didn't help.I just purchased a Denon x4500h. It seems that the MeiHarmonyHub plugin is not sensing the start of the activity. If I fire off the Master TV activity in the Harmony it does nothing. If I run the event with the blue arrow, it turns on Zone 2. Any assistance in getting this to work would be greatly appreciated. I guess I am just trying to figure out how I can bridge the gap between the two and control more devices over the network via my Harmony remote by funneling commands through Homeseer.
I am still new to Homeseer and am slowly learning how to get around. Is it possible to edit these commands for each device, so that they would call commands that I build out in BLDenon? Is there some sort of virtual device that I can create that would show up in the Harmony software so that I can sent commands from my Elite remote to homeseer? It seems like these would just allow me to control devices that are already set up in the harmony hub. I see that it has also created some devices in my list and I see commands for each device. I have my hub set up and I can see which devices are set up on it. I see sample scripts in the help file, but I don't see instructions on where these actually go.
I also see that you can somehow create manual scripts to send IP commands to the Denon, but I have no idea how to do this. However, I would like to control Zone 2 as well and I am not sure how to add devices for this. Changing these actually controls the Denon. I have one of my receivers set up and I see that it has created devices for controlling volume, power and input for ZONE 1 of the Denon.
I have purchased MeiHarmonyHub plugin and have installed the trial of BLDenon plugin. Harmony's IP control is extremely lacking. I am doing this because I am controlling the Denon remotely and need IP control. I would like to be able to send commands using my Harmony Elite / Harmony Hub to Homeseer which would in turn pass them along to the Denon to control it. I am trying to figure out how to get this working and am in need of help.